Go Green and Save Green!

When selecting finishes, select the RoHS compliant finishes. They are better for the environment and less expensive!

DA-4600 Line
Mini Snap-In Receptacle

Mini Snap-In Receptacle Picture Mini Snap-In Receptacle Dimension Drawing

To Determine Receptacle Size and Stud Grip Length Required

Step 1: Find the Support Thickness Range that applies to your Support Thickness in the table. The Part Number of the receptacle needed is stated to the right of your applicable Support Thickness Range.

Receptacle Selection
Support Thickness Ranges Receptacle Part Numbers Z
inch mm inch mm
0.032-0.050 0.81-1.27 4604-12-BK 0.108 2.74
0.051-0.100 1.30-2.54 4604-13-BK 0.158 4.01
Support Thickness
The thickness of the material where the receptacle will be mounted. See Figure below.
Step 2: Calculate the Panel Gap Thickness. Then, in the table below, find the column that applies to the receptacle you selected above and find the Panel Gap Thickness range that applies to your calculated Panel Gap Thickness. The stud length needed is to the far right of your applicable Panel Gap Thickness range.
Panel Thickness
The thickness of the material that contains the stud.
Gap Thickness
The combined thickness of the receptacle top flange (0.055") and stud retainer thickness.; These parts may be nested into recessed holes.
Panel Gap Thickness =
Panel Thickness +
Gap Thickness

Mini Snap-In Receptacle Panel-Gap Thickness Drawing

Receptacles and Panel Gap Thickness Ranges Stud Grip Length
Dim. "G"
4604-12-BK 4604-13-BK
inch mm inch mm
.125-.174 3.18-4.42 .074-.124 1.88-3.15 45
.175-.224 4.45-5.69 .125-.174 3.18-4.42 50
.225-.274 5.72-6.96 .175-.224 4.45-5.72 55
.275-.324 6.99-8.23 .225-.274 5.72-6.96 60
.325-.374 8.26-9.50 .275-.324 6.99-8.23 65
.375-.424 9.53-10.77 .325-.374 8.26-9.50 70
.425-.474 10.80-12.04 .375-.424 9.53-10.77 75
.475-.524 12.07-13.31 .425-.474 10.80-12.04 80
.525-.574 13.34-14.58 .475-.524 12.07-13.31 85
.575-.624 14.61-15.85 .525-.574 13.34-14.58 90
.625-.674 15.88-17.12 .575-.624 14.61-15.85 95
.675-.724 17.15-18.39 .625-.674 15.88-17.12 100

Installation
Support Panel Preparation
Mini Snap-In Receptacle Support Preparation Drawing
Installation Procedures
Mini Snap-In Receptacle Installation Drawing
  1. Angle the long notched side of the top flange into the hole from the underside.
  2. Push the other long side completely through the hole with a flat blade screwdriver.