ST-1200 Line Size 5 Receptacle - Slip-on
The SL Receptacle is installed by slipping it over the edge of the support material and allowing it to snap into a single round hole. Support preparation and installation costs are very low, yet the SL offers performance equal to aircraft-type riveted receptacles of equal size.
|
||
| Technical Information | ||
Locked Service Tension: 45 lb
Max. Load without Distortion: 85 lb
Rated Shear Strength: 200 lb
Wear Life: 25,000 Cycles
Materials:
Clip: Carbon spring steel, heat treated
Spring Plate: Mild steel, zinc plated
S-Spring: Spring-temper music wire
Finish:
Notes:
- Extra receptacle float: Panel misalignment can be tolerated by increasing the support hole to .547" (13.89 mm) and decreasing the hole center to edge distance to .328" (8.33 mm).
- The clip face causes a .020" (.51 mm) gap between panel and support. This gap is assumed in the fastener selection table and it should not be included when calculating "Total Thickness." Stud retainers enter clip and do not add to gap
- With stud locked to receptacle, S-spring deflection should be .024" to .050" (.61 to 1.27 mm).
| Stud/Receptacle Selection: |
The selection table on the receptacle page shows the correct receptacle part number and stud length, based on thickness of materials being fastened. Material thickness P and Q, as shown, are required to use the SL Selection table.
Once stud length is determined, a complete stud part number can be derived from the specifications for the receptacles.
Use the Support Thickness column to select the proper receptacle variation to accommodate your support thickness.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
English inch |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Metric mm |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||
|