Push-Action Fasteners

U. S. A. Flag
Manufactured in
the United States of America!

Push-to-Lock Slide Latch Picture
Push-to-Lock Studs and Receptacles Picture
AR-4610 Line Plastic Fastener

Access fasteners that operate, at least to close, by push-action are growing in popularity. This is due, in part, to the simplicity and speed of the operating motion. At the same time, push-action fasteners in general share a tolerance for thickness variation of the fastened parts that is wide compared to other types of quick-acting fastener.

The fasteners in this section are some of the most convenient to operate of the type that secure panels over supports. In addition, each one offers a rapid and tool-free installation procedure.

AR-4610 Line Plastic Fastener

8404 Push Panel to Lock, Slide to Open Plastic Slide Latch

The 8404 Plastic Slide Latch is held in the closed position by spring tension. A stainless steel spring is nested at the back end of the one-piece latch body, and is contacting the back edge of the panel hole.

When the panel is pushed closed, the sloped pawl edge meets the support corner and slides the latch back. As the panel closes fully, the pawl clears the edge of the support and the spring slides the latch forward to the closed position.

The panel is opened by sliding the latch back with a finger.

This black thermoplastic latch has a clean, flush appearance. The panel hole is always concealed.